!
WARNING
Be sure only trained and qualified service personnel to install, repair or service the equipment.
Improper installation, repair, and maintenance may result in electric shocks, short-circuit, leaks, fire or other damage
to the equipment.
Install according to this installation instructions strictly.
If installation is defective, it will cause water leakage, electrical shock fire.
Install at a strong and firm location which is able to withstand the set's weight.
If the strength is not enough or installation is not properly done, the set will drop to cause injury.
For electrical work, follow the local national wiring standard, regulation and this installation instructions. An
independent circuit and single outlet must be used.
If electrical circuit capacity is not enough or defect in electrical work, it will cause electrical shock fire.
Use the specified cable and connect tightly and clamp the cable so that no external force will be acted on
the terminal.
If connection or fixing is not perfect, it will cause heat-up or fire at the connection.
After completing the installation work, check that the refrigerant does not leak.
Toxic gas may be produced if the refrigerant leaks into the room and comes into contact with a source of fire, such
as a fan heater, stove or cooker.
Use the attached accessories parts and specified parts for installation.
Otherwise, it will cause the set to fall, water leakage, electrical shock fire.
Wiring routing must be properly arranged so that control board cover is fixed properly.
If control board cover is not fixed perfectly, it will cause heat-up at connection point of terminal, fire or electrical
shock.
!
CAUTION
Don't install the air conditioner in the following locations:
■ There is petrolatum existing.
■ There is salty air surrounding (near the coast).
■ There is caustic gas (the sulphide, for example) existing in the air (near a hot spring).
■ The volt vibrates violently (in the factories).
■ In buses or cabinets.
■ In kitchen where it is full of oil gas.
■ There is strong electromagnetic wave existing.
■ There are inflammable materials or gas.
■ Other special conditions.
39