Renfert SILENT TS Manual De Instrucciones página 25

1 Introduction
1.1 Symbols used
The following symbols are employed in these instructions and on the unit itself:
Danger
Immediate risk of injury.
Electrical voltage
Danger due to electrical voltage.
Caution
Risk of damage to the equipment if the instruction is not followed.
Notice
Provides the operator with useful information that eases use.
The equipment complies with applicable EU directives.
This product complies with the relevant UK legislation.
See the UKCA declaration of conformity available online at www.renfert.com.
The equipment is subject to the provisions of the EU directive 2002/96/EC (WEEE directive).
► List, particular attention should be paid
• List
- List
⇒ Instructions / appropriate action / input / operational sequence:
You are asked to carry out the specified action in the order indicated.
♦ Result of an action / response by the equipment / response by the program:
The equipment or program responds as a result of your actions or when a specific incident occurs.
Other symbols are explained as they occur�
2 Safety
2.1 Intended use
This device is designed to extract dry, non-explosive dust�
The unit is intended solely for use in a commercial dental laboratory and dental practice�
The intended use also includes compliance with the conditions specified by the manufacturer concerning
operation and maintenance�
The extraction unit can be used in combination with a SILENT flow sensor within the scope of measures
to protect against exposure to dust *) as defined by the German ordinance on hazardous substances
("GefStoffV") / respective employers' liability insurance association�
For this purpose, the information on low-dust disposal of the extracted material (chapter "Emptying the
dust drawer") and on low-dust replacement of the fine filter (chapter "Replacing the fine filter") in particular
must be observed�
In doing so, both the instructions for use of the extraction unit as well as those of the SILENT flow
sensor must be observed.
*) Note for customers in Germany: A validated and recognized dust protection measure in accordance with testing
principle GS-IFA-M20 (issued by the German Institute for Work and Health IFA) shall only be deemed to have
been provided when all components, i.e. the flow rate monitoring unit such as the SILENT flow sensor, the ex-
traction unit, and the detection unit, are validated and recognized�
In the case of multi-workbench extraction units and the use of Y-junctions or extractor switches, every suction
channel / every suction point must be fitted with a flow rate monitoring unit.
- 3 -
en