Idiomas disponibles
Idiomas disponibles
GB
MT
6. Select the smart Performance battery
with which you are operating the device
by setting the check mark
only one device at a time. If there are
other check marks for other devices, cle-
ar the check marks by pressing them.
7. Now press the
lour as the set check mark.
8. Confirm the successful connection with
"Finish".
The device is now listed on the tab
"At home" and can be selected.
If you have already connected other
devices to the app:
"At home", select the
4. On the tab
in the upper right. The app scans the
area for available devices and indicates
if available devices have been found.
If this is not the case, read on if
possible
5. Proceed as with
If a list of available devices is not auto-
matically suggested to you:
If the smart battery is not suggested auto-
matically, follow these steps:
"At home", select the
4. On the tab
in the upper right.
5. Select "Other" in the bar on the left.
6. Select "Lidl Smart Battery".
7. Follow the instructions in the app.
If you have already connected the
smart battery to the app:
4. Select the tab
5. Select the smart battery (that you are
using for the device). An extra symbol
on the right indicates that the smart
battery is connected to a Performance
device.
42
. Select
that has the same co-
.
from point 5.
"At home".
Upgrading the firmware can change
the features of the app.
Features of the app
Select the smart battery that you are
using for the device. This takes you to the
overview page for the device with the
following information and settings:
If you are not immediately directed to
the overview page of the device,
select the Performance device under "De-
vice information" on the overview page of
the battery.
- The Tool Virtual ID helps you identify the
exact tool
- The Tool Model and production batch
are indicated
- The Tool Discharge Current indicates the
current discharge in amperes
- The Tool Rotation Speed indicates the
current speed per minute
- Various working modes can be selected
via Tool in Working Mode. The rotation
speed can be set in Expert Mode.
Level 1 and 2 on the control panel
light up in this setting.
- The Current Level indicates the current
speed level of the machine. It can be
changed by selecting it.
- The Tool Total Runtime can be read out
- The frequency of the overtemperature
times can be read out via Tool
Overtemperature Times
- The frequency of the Tool Lock Times can
be read out
- The frequency of the Tool Overcurrent
Times can be read out
- A red dot next to the Firmware Version
indicates if an update is available. The
update can be installed by tapping the
firmware version
