Tabla de contenido
Idiomas disponibles
Idiomas disponibles
To adjust the tension of the bolt, keep handle in the
down position, back nut off, adjust bolt tension and
re-tighten nut.
BAG
2
Loosely assemble round head bolt, bolt pad,
handle and hex nut as shown.
Attach Support Arms
Slide support arm pads, along with round
head bolt and bolt pad, into side T-slot. This
can be done from either side.
1
Adjust Tool Mount Handle
With handle pointing down, lightly turn bolt,
counter-clockwise, with screwdriver until snug
(be careful not to over tighten). Continue to
hold handle in the downward position, keep-
ing bolt from rotating with screwdriver, and
tighten nut clockwise with 1/2'' wrench.
Repeat assembly with second support arm.
Arm should slide freely with handle in the
unlock position, but be rigid when handle is
tightened.
2
Insert end cap onto main beam end. Use a
3/8" open-end wrench to install and tighten
two #14 self tapping screws. Do not over
tighten. Repeat with second end cap.
Note: These end caps also serve as support
arm safety stops.
4
SUPPORT ARM
Install End Caps
3
Tabla de contenido
