Idiomas disponibles
Idiomas disponibles
the steam and rub off any residue immediately
with a thickly folded, damp cotton cloth.
3. To keep the soleplate smooth, you should
avoid hard contact with metal objects.
Never use a scouring pad, or chemicals to
clean the soleplate.
Multiple descaling system
AntiCalc
See the leaflet sides
a
"self-clean"
The "self-clean" filter between the water tank and
the pump prevents scale impairing the steam
generation system and ensures the optimum
production of steam.
B
"Calc'nClean"
The "Calc'nClean" function helps to remove
scale particles out of the steam chamber. Use
this function approximately every 2 weeks if the
water in your area is very hard.
Follow the procedure described below:
1 Unplug the iron from the mains socket, and fill
the water tank (11) with water.
2 Set the temperature selector (15) to the "max"
position and plug in the iron.
3 After the necessary warm-up period, the
"TempOK" lights inside the temperature
control stop flashing. Then, unplug the iron
(very important!).
4 Hold the iron over a sink. Press the
"Calc'nClean" button (16) and shake the
iron until approximately one third of the
water capacity of the tank is evaporated.
Boiling water and steam will come out,
carrying scale or deposits that might be
there.
5 Release the "Calc'nClean" button, and gently
shake the iron for some seconds.
6 Repeat the steps 4 and 5 three times until
the tank is empty.
7 Then plug the iron in and heat it up again
until the remaining water has evaporated.
Push the "Calc'nClean" button a few times
more to clean the valve.
8 Unplug the iron and let the soleplate cool
down. Wipe the soleplate with a damp cotton
cloth only.
* Model dependent
C
"Calc'nClean" with descaling liquid *
For deep descaling, it is recommended to use
the descaling liquid especially developed by
Bosch. This procedure should be carried out
every 3 months.
1. Unplug the iron from the mains socket.
2. Fill the water tank with tap water mixed with a
measure (25 ml) of the descaling fluid (19*).
3. Then follow the procedure described above in
section "Calc'nClean" (steps 2 to 8).
The descaling liquid may be purchased from the
customer service or specialist shops.
Name of accessory: TDZ1101
D
"
-calc"
anti
The "anti-calc" cartridge has been designed to
reduce the build-up of scale produced during
steam ironing, helping to extend the useful life of
your iron. Nevertheless the "anti-calc" cartridge
cannot prevent all of the scale that is produced
naturally over time.
"TextileProtect"
soleplate cover *
TextileProtect
See the leaflet sides
The "TextileProtect" soleplate cover (20*) is
used for steam-ironing delicate garments at
maximum temperature without damaging
them.
The fabric-protection soleplate cover may be
purchased from the customer service or
specialist shops.
Name of accessory: TDZ1550
"StoreProtect" *
StoreProtect
The "StoreProtect" device (21*) enables an
immediate and safe storage of the iron, even
with a hot soleplate.
The protector may be purchased from the
customer service or specialist shops.
Name of accessory: TDZ1750
19
BOS CH
