Tabla de contenido
Idiomas disponibles
Idiomas disponibles
LED
Action
LED flashing in blue every 2 seconds
LED flashing in blue twice every 5 seconds
LED flashing in blue rapidly and
continuously
LED lighted up alternating between blue
and red
LED flashing in red
LED lighted up in red
Battery charge
It is necessary to charge the battery for 2 hours before using the headset for the first
time. Therefore, follow this procedure:
1. With the headset turned off, connect the USB cable in a USB port, or connect it
to an electrical outlet using the voltage adaptor;
2. Connect the other end of the cable to the USB charger connector of the headset.
The LED will light up in red.
After the first charge, the battery must only be recharged when the LED flashes in
red and this sequence of beeps is emitted: 1 beep every 5 seconds three times, an
interval of 20 seconds and 1 beep every 5 seconds three times. Recharge it until the
red LED turns off.
Note: charging time is approximately 1.5 hours.
Operation
Turning on and off
To turn on the headset, press the main button for approximately 7 seconds until the
LED lights up in blue.
To turn off the headset, press the main button for approximately 3 seconds. The LED
will flash in blue once and then remain off.
Status
In rest mode and disconnected from other
Bluetooth® device
In rest mode and connected to Bluetooth®
device
In conversation
In synchronization mode with another
Bluetooth® device
Low battery
Charging battery
23
Tabla de contenido
