5.
To Re-set the Compliance Meter
1.
Press "MENU" to select [CM XXXX.X hr] menu while in the standby screen.
2.
Hold the "UP" and "DOWN" button, and then simultaneously press the "MENU"
button for one second. Meanwhile, [CM XXXX.X hr] will start blinking and
"CLEAR " will show on the LCD display.
3.
Press "UP" or "DOWN". The LCD screen will show "CLEAR OK".
4.
Press "MENU" to confirm the reset function and the compliance meter record will be
erased so the value becomes 0.0 hr. During the erasing process, [CM 0000.0 hr]
will be blinking and once the process finishes, "CLEAR OK" will disappear.
5.
Press "START/STANDBY" button to go back to standby screen or leave the device
to automatically go back to standby screen 20 seconds later.
6.
To View and Re-set the Total Meter (for XT Sense / XT Prime / XT Auto)
1.
Once the device is powered, before it shows "STANDBY" screen, press "MENU" &
"START/STANDBY" buttons simultaneously to view Total Meter Hours.
2.
If the total meter hours have reached 9999.9 hours and you want to reset it, press
"UP" button, [TM XXXX.X hr] will start blinking and "CLEAR " will show on the
LCD display.
3.
Press "UP" button. The LCD screen will show "CLEAR OK".
4.
Press "UP" to confirm the reset function and the total meter record will be erased so
the value becomes 0.0 hr.
5.
Press "START/STANDBY" button to go back to standby screen.
7.
To Download the Usage Data (for XT Prime / XT Auto)
Please refer to Easy Compliance CPAP Data Management Software instruction. Use the
USB cable to connect the device to a computer which has been tested and approved to
IEC60601-1 or IEC60950 standard.
CAUTION – Do not connect the device to the personal computer for data downloading
during treatment. This may cause failure of the system.
NOTE – These additional instructions are separated because of concerns with rental
service management and accidental wrong setting by others. Please do not
distribute to patients.
English
2
