Idiomas disponibles
Idiomas disponibles
◼
Installation
⚫
Install the display unit
1. Use two M3*12 hexagon socket screws 1-1 and 1-2 to lock the left and right
brackets to the handlebars. Tightening torque: 0.2N.m. Do not over-tighten,otherwise
it will cause damage to the display.
2. After adjusting the display to a proper angle, use two M3*6 hexagon socket screws
2-1 and 2-2 to tighten it.
3. If you want to install it on a 22.2mm or 25.4mm handlebar,
please use the attached adapter rubber ring.
⚫
Install the button unit
1. Use one M3 hexagon socket screw 3 to lock the control
unit on the left handlebar, the recommended position: the
right side of the brake fixing ring.
2. Tightening torque: 0.2N.m. Do not over-tighten, otherwise
it will cause damage to the instrument.
⚫
Connect the cable
1. Align the arrow marks on the outlet connector of the meter and the Ebike outlet
connector, and insert the two cables firmly
2-1
1-1
Arrow mark
Arrow mark
EN
1-2
14
2-2
fixing
3
