Idiomas disponibles
Idiomas disponibles
Product installation
1.The state of the bicycle after being taken out of
the carton is as shown in the figure above. First,
cut all the nylon straps to ensure that the front
wheel can be smoothly separated from the frame
when the rear wheel can rotate freely.
6.Insert the front axle quick release screw into
the front axle core, tighten it with the nut, and
then press the quick release handle to lock the
front fork.
：
3.Loosen the fixing screws of
the front fork protection rod
with an adjustable wrench,
and remove the front fork
protection rod.
5.Open the accessory small carton, take out the front axle quick
release inside, loosen the nut and separate it from the screw.
2.Turn the bicycle upside down as shown above to
facilitate the installation of the front wheels.
4.Place the front wheel on the front fork for
installation, pay attention to the disc brake pad
and the disc brake to match in place.
7.After the front wheel is installed, remove all the
protective foams, and then place the bicycle as
shown above.
EN
04
