Idiomas disponibles
Idiomas disponibles
English
Always follow the safety rules stated in this manual.
7.1. HOLDING OF THE MACHINE AND GUIDANCE
Put on the fastening tape as shown in the figure and
hook it to the machine by the ring.
Sujete la máquina con el arnés, la manos en el
manillar con la mano derecha colocada de manera
que pueda actuar en los controles (acelerador e
interruptor de seguridad).
Attention !: In order to reduce the risk of loss of
control and possible damage (even fatal) to the user
or to nearby persons, never use this machine with one
hand.
7.1.1. CUT WITH THE NYLON HEAD
WARNING: Wear eye and audible protection at all
times. Do not look directly to the cutting line because
can cause serious damage to the head and the eyes.
Use the head line in difficult areas.
If the header hits a rock or other object stop the
machine and check its status. Do not use damaged or
poorly balanced heads.
Hold the brush cutter in the way that the head do not
touch the ground and with an inclination of 20º in the
sense you are cutting.
Make cuts from the left to the right to prevent that the
grass fall into the cutting area. Be careful to not hit the
head with rocks or the ground. The beatings against
objects or the ground will reduce the life of the head,
may spoil creating a dangerous environment for you
and the people close to you.
The nylon threads are shortened with the use, when
they are too short accelerate the engine and press the
head against the ground. Then leave wire from the
head. If you leave too much wire the blade will cut in
excess.
Remember that the end of the nylon threat is the one
that makes the cut. Get a better result if you do not
introduce the entire head in the cutting area. Enter
the head slowly and let the nylon tips cut the grass at
their own pace.
WARNING DANGER: Do not operate the brush
cutter in areas with metallic materials.
Always use the proper protective equipment. Don't use
this machine in areas where you can't see properly.
7.1.2. CUT WITH THE DISC
Check the disc holder and make sure it is tight and
there are no signs of damage or abrasion.
Make sure the disc and disc holder are firmly installed
in accordance with the instructions and that the disc
spins freely without producing abnormal sounds.
CUTTING METHOD:
- Cut with the left front of the disc.
- Always cut to the left keeping the disc slightly
inclined to the left.
IMPORTANT:
56/174
