Idiomas disponibles
Idiomas disponibles
USING THE ALARM
alarm has two protection modes: Full mode (all detections activated) & Eco mode (only the optional functions
Your Beeper
XRAY XR2
are active, the shock sensor is deactivated).
1. Full Mode
To activate the alarm in full mode, press button
indicate system activation.
In this mode:
• In the event of a slight shock, the siren sounds 5 times then stops (= first level of the shock sensor).
• In the event of a major shock, the siren sounds for 30 seconds then stops (= second level of the shock sensor).
• If multiple light shocks are detected within 10 seconds, the siren sounds for 30 seconds and then stops.
• If the optional functions trigger the alarm (eg door opening, ignition, etc.), the siren sounds continuously.
To deactivate the alarm, press button
2. Eco mode
To activate the alarm in eco mode, press button
The siren beeps again and the LED starts flashing to inform you that the eco mode is activated.
/!\ Important /!\
In this mode, the shock sensor is disabled. Only optional functions can trigger the alarm. If no optional function connected (WHITE,
ORANGE & BLUE cables), no active detection.
To deactivate the alarm, press button
3. Vehicle detection function / Panic mode
To detect the vehicle (or panic mode), it is necessary to perform 3 consecutive slow presses on button #3
#3
once. The siren will ring once and the LED lights up for 10 seconds then flashes to
#1
once. The siren rings twice and the LED goes out.
#3
once. The siren will ring once. Press button
#1
once. The siren rings twice and the LED goes out.
17
#3
again.
.
