Idiomas disponibles
Idiomas disponibles
BEFORE INSTALLATION
Thank you for choosing a product from the BEEPER range for your vehicle. BEEPER products have been designed and
produced for your complete satisfaction. We advise you to have this product installed by a professional and to read this
guide for perfect use of the product. Our technical department is at your disposal for any further information.
Please follow the following advice before installing the system:
•
The system operates under 12V direct current (12 V DC). Be sure of the polarity of each wire.
•
Check before installation if all the elements of the vehicle are working correctly such as ignition & engine start, ignition codes, lights
and headlights, indicators, heating, air conditioning, door locks, ... Check after installation that all these same elements are working .
•
When you connect the general GROUND of the system, it is very important that this ground is frank and totally stable (no leaks).
•
Make sure that all wires passing through tight places are protected with tape to prevent excessive twisting and degradation of the
plastic protection of the wire with the risk of bad contacts.
•
Make sure that the wires of the system as well as all the security accessories are as well concealed as possible in the vehicle, never
forget that you are installing a security system.
•
Use a digital multimeter to locate each of the wire polarities.
•
Take care not to disconnect the battery if the vehicle has a code car radio.
•
If the vehicle is equipped with an AIRBAG, take care not to disconnect the battery from the vehicle, nor to connect the wires without
certainty.
•
Remove the dome light fuse when installing the system to avoid draining the battery (doors open).
XRAY = MULTIPLEXED VEHICLES
The BEEPER XRAY system is compatible with all multiplexed vehicles on the market.
BEEPER systems are compatible with the European car fleet and their installation cannot invalidate or modify the
conditions of the vehicle warranty.
13
