Flex Base Wires Inward
Tubes de la base courbés vers l'intérieur
Flexionar cables de base para adentro
4
• While flexing the base wires toward each other,
hook the footrest onto the ends of the base wires.
• Push the footrest down completely to the tabs on
the base wires.
• Tout en courbant les tubes de la base l'un vers l'autre,
glisser le support du repose-pieds sur l'extrémité
des tubes.
• Pousser le repose-pieds complètement vers le bas,
jusqu'aux butées des tubes de la base.
• Mientras flexiona los cables de la base uno hacia el otro,
enganchar el reposapiés en los extremos de los cables
de la base.
• Empujar el reposapiés hasta abajo a las lengüetas
de los cables de la base.
Assembly
Assemblage
Tabs
Pattes
Lengüetas
Montaje
BEND
DOBLEND
DOBLEL
5
• Position the seat back tube above the base assembly.
The seat back tube should bend backward.
• Fit the seat back tube completely onto the base wires.
• Fit a retainer (rounded side inward) to one end of the
seat back tube.
" (2.2 cm) screw through the outside
• Insert a #8 x
7
/
8
hole in the seat back tube and into the retainer.
• While holding the retainer in place, tighten the screw
with a Phillips screwdriver. Do not over-tighten.
• Repeat this procedure to secure the other side of the
seat back tube to the base assembly using the remaining
retainer and #8 x
7
• Pull up on the seat back tube to be sure it is secure.
If you can remove either end of the seat back tube,
you have not assembled it correctly. Remove the screws
and retainers. Re-read and repeat Assembly step 5.
8
Seat Back Tube
Tube du dossier
Tubo del respaldo
Retainers
Bagues de retenue
Retenedores
Pull Up
Tirer
Jalar para arriba
/
" (2.2 cm) screw.
8
