Idiomas disponibles
Idiomas disponibles
10. Programme Turny Evo
10.1
Activate the programming menu
Hold down the yellow button until the
"enter code" screen is displayed. Then
enter the code 1, 2, 3, 4
10.2
Programme movement paths
Turny Evo has three motors, a lengthwise, swivelling and lifting motor. These
motors must be programmed to create two separate movement paths for the
seat, a "comfort" and a "swivel out".
The movement path "comfort" is the lengthwise path that the seat follows
when the car door is closed. The movement path "swivel out" is the combined
swivelling and lifting path that the seat follows when the car door is open.
Programme the swivel and lift movement as close as possible to the B pillar to
maximise the legroom. The programmed path can vary by +/- 5 mm. Pro-
gramme with an approx. 15 mm margin to prevent damage to the product
and car. If you transfer to and from Turny Evo using a wheelchair, programme
so that the seat stays below the wheelchair's seat height. There is also a margin
to cope with transferring on uneven surfaces.
Use "gradually swivel out" first to achieve a gentle, smooth
movement path. At the same time, always strive to keep the
programming simple with as few steps as possible for the
same reason. Fewer steps also minimises the risk of errors
arising in the program. When first programming it can be
difficult to achieve the optimal path. There is therefore the
ability to save programming at any time and then directly go
into editing mode to do any fine tuning required.
Getting seated Turny Evo
B pillar
35
EN
