Autoadapt Turny Evo Manual De Instalación página 28

Ocultar thumbs Ver también para Turny Evo:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 77
28
Turny Evo
Getting seated
7. Mount seat belt
Always strive to achieve the following seat belt geometry as illustrated below.
Specified degrees are obtained from the legal requirement /
ECE R-14, Revision 5, seat belt attachment points
Female connector
If the original belt has any kind of belt pretensioner or switch, the wiring must be
adapted for connecting to the Turny Evo. The illustration on the next page shows a
right-swivelling Turny Evo.
7.1
Cut off original connectors
Cut off original connectors on low-
er anchor point, female connector
and associated wiring on the floor
under the seat.
80-45°
7.2
Wire in new connections
Replace original connections
according to the illustration on the
next page with supplied wire in
connections. Ensure that the cable
colours on the wire in connections
match the same cable on Turny
Evo.
Lower anchor point
30-80°
7.3
Mount belt
Mount according to the illustration
on the next page using supplied
z-iron, nuts, bolts. Use a washer
if the hole pattern in OEM belt
attachment is too big for the nut.
loading