Stihl FSA 90 R Manual De Instrucciones página 21

During Operation
1
Press button (1) to activate the
N
display – the display goes off
automatically after 5 seconds.
The green LEDs glow continuously or
flash to indicate the state of charge.
80 - 100 %
60 - 80 %
40 - 60 %
20 - 40 %
0 - 20 %
If the LEDs on the battery flash or glow
red – see "If the red LEDs glow
continuously / flash".
FSA 90 R
If the red LEDs glow continuously / flash
A
B
C
D
A 1 LED glows Battery is too hot
1) 2)
continuously /cold
red:
B 4 LEDs flash Malfunction in
red battery
C 3 LEDs glow Machine is too hot
continuously – allow it to cool
red: down.
D 3 LEDs flash Malfunction in
red machine
1)
When charging: Charge process
starts automatically after the battery
has cooled down / warmed up.
2)
During operation: Machine cuts out
– allow battery to cool down; it may
be necessary to take the battery out
of the machine for this purpose.
3)
Electromagnetic problem or fault.
Take the battery out of the machine
tool and refit it. Switch on the
machine – if the LEDs continue to
flash, the battery is faulty and must
be replaced.
4)
Electromagnetic problem or fault.
Take the battery out of the
machine. Use a blunt tool to
remove dirt from the contacts in the
battery compartment. Refit the
battery. Switch on the machine – if
the light emitting diodes still flash,
the machine is faulty and must be
checked by a servicing dealer –
STIHL recommends an authorized
STIHL servicing dealer.
1)
3)
4)
English
19