Idiomas disponibles
Idiomas disponibles
Dimplex Opti-myst Inset Fires
Model: Cavendish CSH20 (Brass Inset), Chesford CSD20 (Titanium Inset)
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Important Safety Advice:
When using electrical appliances, basic precautions
should always be followed to reduce the risk of fi re,
electrical shock and injury to persons, including the
following:
If the appliance is damaged, check with the supplier
before installation and operation.
Do not use outdoors.
Do not use in the immediate surroundings of a bath,
shower or swimming pool.
Do not locate the heater immediately below a fi xed
socket outlet or connection box.
This appliance is not intended for use by children
or other persons without assistance or supervision
if their physical, sensory or mental capabilities
prevent them from using it safely. Children should
be supervised to ensure that they do not play with
the appliance.
Do not use this heater in series with a thermal
control, a program controller, a timer or any other
device that switches on the heat automatically,
since a fi re risk exists when the heater is accidentally
covered or displaced.
Ensure that furniture, curtains or other combustible
material are positioned no closer than 1 metre from
the heater.
In the event of a fault unplug the heater.
Unplug the heater when not required for long
periods.
Although this heater complies with safety standards,
we do not recommend its use on deep pile carpets or
on long hair type of rugs.
The appliance must be positioned so that the plug is
accessible.
If the supply cord is damaged it must be replaced
by the manufacturer or service agent or a similarly
qualifi ed person in order to avoid a hazard.
Keep the supply cord away from the front of the
heater.
WARNING: In order to avoid overheating, do not
cover the heater. Do not place material or garments
on the heater, or obstruct the air circulation around
the heater.
The heater carries the Warning symbol
indicating that it must not be covered.
General.
Unpack the heater carefully and retain the packaging
for possible future use, in the event of moving or
returning the fi re to your supplier. The Remote Control
and batteries are packed separately in the carton.
The fi re incorporates a fl ame eff ect, which can be used
with or without heating, so that the comforting eff ect
may be enjoyed at any time of the year. Using the
fl ame eff ect on its own only requires little electricity.
The heater is designed for use inset into a 407mm (16") or
457mm (18") wide by 559mm (22") high fi replace opening
or freestanding - see also section 'Installation Instructions' .
Before connecting the heater check that the supply
voltage is the same as that stated on the heater.
Please note: Used in an environment where background
noise is very low, it may be possible to hear a sound which
is related to the operation of the fl ame eff ect. This is
normal and should not be a cause for concern.
Electrical connection.
WARNING – THIS APPLIANCE MUST BE EARTHED.
This heater must be used on an AC ~ supply only and the
voltage marked on the heater must correspond to the
supply voltage.
Before switching on, please read the safety warnings and
operating instructions.
PLEASE RETAIN THIS USER'S GUIDE FOR FUTURE
REFERENCE
Do not put Opti-myst plastic components into a
dishwasher.
Only slide out the drawer when the water tank needs
to be fi lled or a lamp needs to be changed otherwise
you will inadvertently alter the water level and the
fl ame eff ect operation.
Only use fi ltered tap water in this appliance.
Always ensure that the appliance is sitting on a level
fl oor.
If you intend not using the appliance for longer than 2
weeks, drain the water from sump and water tank and
dry the sump.
Once installed, never move this appliance or lay on its
back, without draining the water from sump and water
tank.
The water tank, sump, sump lid, tank cap and air fi lters
must be cleaned once every two weeks, particularly in
hard water areas.
The appliance should never be operated if the lamps
are not working.
The lamps should be regularly inspected as described
under 'Maintenance' and 'Changing lamps' .
- 1 -
