Idiomas disponibles
Idiomas disponibles
exhauster performance and the appearance at
times of an anomalous noise on starting up the
exhauster. Replace filters as indicated above.
The unit has a protective system to prevent
sudden start-ups. If the electrical power supply
to the polisher motor is cut off it stops, but when
power is restored the machine might start up
unexpectedly and anyone manipulating the
motor shafts at the time might suffer injury. To
prevent this Talleres Mestraitua, S.L. has fitted
the Ref. 080500 with an automatic switch which
turns it off in case of a power failure. If this
happens during operation the device will have
to be reset before work can continue. Do this as
follows:
1. Switch off the unit via switch (B).
2. Raise the top dust guard (A).
3. Locate the automatic off switch (between
switches (B) and (C) ).
4. Reset the automatic off switch by pressing
it.
5. Fit the dust guard (A).
PRECAUTIONS
Before connecting the unit ensure that the
power supply is 230 V, 50/60 Hz earthed power
outlet.
Discard any brush or grinding wheel with
cracks, knocks or flaws. Breakage of these
components during operations could cause
serious accidents.
Before starting work ensure that the brush-
holder/wheel holder is firmly coupled to the
motor shaft.
When handling workpieces use safety goggles,
gautles and mask.
Do not allow children or unskilled personnel to
handle the unit.
Never polish, brush or grind materials which
might give off particles which are toxic if
inhaled.
Before starting to polish or grind a workpiece,
ensure that the motor shaft spin direction is
correct (red arrow on motor stator). Attack
angle depends on spin direction.
Do not use the unit near solvents, alcohol or
other inflammable materials. Take extreme care
when grinding materials which may give off
sparks.
Before using the unit ensure that it is set up on
a firm solid base.
Do not use the unit without the exhauster on
unless the nature and characteristics of a
specific job require that it be disconnected. In
this case keep working time as short as
possible.
TECHNICAL CHARACTERISTICS
Height:
Width:
Depth:
Weight:
Power supply:
Speed (rpm):
Noise level:
Exhauster flow rate:
English
500 mm
800 mm
500 mm
60 kg
230 V, 50/60 Hz
1500/3000, 50 Hz
1800/3600, 60 Hz
67 dB
3
500 m
/hora
