Idiomas disponibles
Idiomas disponibles
PRODUCT SHEET
1. Control panel.
2. Perimeter extraction panel
3. Grease filter
4. Light
5. Telescopic flue
Warning! The hood can support a maximum weight of 5 kg
Bulb maintenance
1. Disconnect the electrical power supply.
2. Use a small screwdriver or any other suitable tool to prise
off the lamp cover (Fig.1).
3. Remove the burnt-out bulb.
4. Use G4 20W max halogen bulbs only, taking care not to
touch them with your hands.
5. Close the lighting unit (snap-on).
Perimeter extraction panel maintenance:
Clean the perimeter extraction panel as often as the grease
filter, using a cloth and a not too concentrated liquid
detergent. Never use abrasive substances.
Removing the perimeter extraction panel:
Pull the panel firmly towards you Fig.2.
Warning! Hold the panel with both hands when you remove
it or replace it, to prevent it from falling and causing damage
or injury.
Fitting the perimeter extraction panel:
Refit the panel and secure it using the fastening pins located
on the surface of the hood.
Warning! Always check to ensure that the panel is firmly
fixed in place.
Grease filter maintenance:
1. Disconnect the electrical power supply.
2. Remove the grease filter/s (Fig. 3). To remove, pull
the spring loaded release handle back (f1) then extract the
filter downwards (f2)
Carbon filter maintenance
(only for filtering hood installation models):
Fit a new carbon filter every 4 years
Fitting or renewing the carbon filter (Fig.4):
1. Disconnect the electrical power supply.
2. Remove the grease filters.
3. If the carbon filters are already mounted (two filters covering
the motor protection grille) and need renewing, turn the
central handle anticlockwise until the filters release.
4. If the filters are not already fitted, locate one on each side
to cover both motor protection grilles, then turn the
central handle of the filters clockwise.
5019 618 33085/A
D
GB
F
NL
All manuals and user guides at all-guides.com
E
P
I
GR
5. Refit the grease filters.
CONTROL PANEL
Light switch.
Press the button to switch on the lights.
Extraction speed selection switch.
Press the button to select the extraction speed.
Keep the button pressed for 2 seconds to switch OFF.
Abb. 1
N
FIN
PL
S
DK
Abb. 2
f1
f1
f2
f2
Abb. 3
Abb. 4
CZ SK
H
RUS BG RO
LI25DA
