Idiomas disponibles
Idiomas disponibles
WARNING
:
and other construction activities contains chemicals known to the state of
california to cause cancer, birth defects or other reproductive harm. Some examples
of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work.
To reduce your exposure to these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to filter
out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling,
and other construction activities. Wear protective clothing and wash exposed
areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
WARNING
: u
cause serious and permanent respiratory or other injury. Always use NOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles away
from face and body.
Symbols
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
or DC ..direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
............Read instruction manual before use
................Use proper eye protection
• When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting
in loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next
heavier gage. The smaller the gage number, the heavier the cord.
volts
120V
240V
Ampere Rating
More
Than
0
6
10
12
Some dust created by power sanding, sawing, grinding, drilling,
se of this tool can generate and/or disperse dust, which may
Minimum Gage for cord Sets
0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more
Than
-
6
18
-
10
18
-
12
16
-
16
14
A ...................amperes
W ..................watts
or AC......alternating current
n o .................no load speed
..................earthing terminal
................safety alert symbol
.../min or rpm...revolutions or
..................Use proper respiratory protection
..................Use proper hearing protection
total length of cord in feet
26-50
51-100
51-100
101-200
American Wire Gage
16
16
16
14
16
14
12
Not Recommended
4
reciprocation per minute
101-150
201-300
14
12
12
