Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Terminating operation
Press the ON/OFF switch. The display-lighting and the pilot
lamp will go out. All settings will be reset.
Overheat protection
When the water is used up, the device will turn off after some
time. All settings will be reset. A signal tone will sound. The
display backlight and control lamp will turn off.
WARNING:
The device is still connected to the mains!
•
Terminate operation by disconnecting the plug. Or refill with
cold water.
NOTE:
•
The device will always switch into standby mode auto-
matically after the heating element has cooled down.
•
The display and the pilot lamp will light up blue. The ap-
pliance is ready for use.
•
This procedure might take up to 30 minutes, depending
on whether or not you have refilled with water.
•
If you would like to continue operation, set the steaming
time again.
WARNING:
• Before cleaning, always disconnect the mains plug and wait until
the device has cooled down completely.
• Do not immerse the base unit of the steamer in water for cleaning.
This might otherwise cause electric shock or fire.
CAUTION:
•
Do not use wire brushes or other abrasive objects.
•
Do not use sharp or abrasive cleaning agents.
Surface of base unit
•
Wipe the surface of the base unit only with a damp cloth
and dry with a soft cloth afterwards.
Reservoir
•
Pour the remaining water from the reservoir.
•
Use a cloth to wipe the reservoir dry.
Adding more water
At maximum water level (1 liter) the water will be used up after
approx. 50 minutes.
Please observe the water level indicator. We recommend to
already refilling with water as soon as the water reaches the
MIN marking. It is possible to do so during operation.
•
Use a measuring cup.
•
Add water through the
water inlet.
•
Fill the reservoir till the
MAX level.
1. Press the ON/OFF switch. The display-lighting and the pilot
lamp will go out.
2. Disconnect the plug from the mains.
WARNING:
•
Always use pot holders or oven mitts when handling or
removing hot components in order not to get burned by
hot steam!
•
The liquid in the collection tray is hot!
3. Remove the steam bowls first and the collection tray last.
Cleaning
Lid, steam bowls, collection tray, rice bowl
CAUTION:
Do not clean these parts in the dishwasher. The clear plastic
surfaces could otherwise tarnish.
•
Clean these parts manually in soapy water.
•
Rinse under clear water and dry afterwards.
In hard water areas scale might build up on the heating ele-
ment. This might result in the steam turning off before the food
is cooked.
Stop operation
Descaling
49
Tabla de contenido
