Schulz FSB 13P Manual De Instrucciones página 52

FIGURE 8.3 FIGURE 8.4
5.3. Fixing the spindle head set on the column:
• Place the Spindle Head Set 1 on the column 4 carefully.
• The set must slide on the column.
• Align the center of the Spindle Head Set with the center of the column and base.
• Tighten the two sets of bolts found on the right side of the Spindle Head Set using the Allen Tool G (Figure
8.5).
5.4. Installing the feed handle:
• Screw the knobs on the handles.
• Screw the feed handles in the holes on the pinion shaft 21 (Figure 8.6)
FIGURE 8.5 FIGURE 8.6
5.5. Connecting the chuck to the spindle/morse taper:
• Attach the chuck guard 21 to the spindle through the Philips screw.
• Align in the chuck 17 with the spindle 14 and the latter with in the head set 1.
• Slide the table 7 upwards, around 150mm away from the end of the spindle.
• Open the drill chuck jaws completely by turning it anti-clockwise.
• Fit the spindle with the chuck, by pressing upwards so that the chuck couples with the spindle (Figure 8.7).
Note: the drill chuck that comes with the machine is available for drill bits from 3 to 16mm - model 16 and from
1,5 to 13mm - model 13.
52