Important Notice - Zummo Z14 NATURE Manual De Usuario

Ocultar thumbs Ver también para Z14 NATURE:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 3
Z14 Self-service Mode:
-
Faucet tray, Juice tray and Blade are removed by unscrewing the fastening nuts and pulling
outwards horizontally (Fig. 9). Unscrew the Balls inside the Juice tray; there is one washer
underneath each Ball (Fig. 10). Be careful not to lose them! You may use a dishwasher to
wash Juice tray, Filter and Blade (except the faucet tray). TAKE EXTRA CARE WITH THE
BLADE (Fig. 2) since it is very sharp and may cause injuries.
-
Wash the faucet tray using a damp cloth.
( ATTENTION! NEVER use products that may scratch it).

Important Notice:

In case of damage due to improper cleaning, the warranty will not apply.
Assembly
After cleaning the whole unit, it is re-assembled as follows:
Fit the Cups on the machine front shafts and tighten the Fastening Nuts (Fig. 8).
1
Fit the washers on the Juice tray and screw the Balls, making sure they are properly tightened
2
(Fig.10).
Insert the blade in the squeezer tray and slot the ribs into the grooves of the balls. Check that
3
the blade slides easily.
Assemble both Juice tray and Blade in the machine's three shafts simultaneously. Never fit the
4
Blade on the Juice tray afterwards!! To introduce the Blade into the Blade shaft, slightly
press down the Blade push it into the shaft. ATTENTION!!! Never press down the metal
part of the Blade.
Fit the shafts and the pulp scraper filter in the filter, fit the filter correctly in its position in the filter
5
tray, self-service tray (THE DRIVE SHAFT SHOULD OVERHANG THE TRAY) (Fig. 11-12) and
fit the set into the machine. Check that the tray or tank is fitted properly which will also indicate
that the filter is in the right position (THE DRIVE SHAFT SHOULD DOVETAIL WITH THE
HEXAGONAL FILTER ACTUATOR).
Fit the Front Cover in place by fitting its clasps into the slots. Make sure that the clasps fit
6
correctly into the slots. You will hear a small click (Fig. 13).
Before operating the machine, make sure that:
Juice tray and Blade are properly fitted in place.
Fastening Nuts are properly tightened.
The correct set of squeezing parts (Balls, Cups and Fruit Selector) are fitted.
If Blade, Juice tray, Balls or Cups are not correctly assembled, serious damage may be caused to these
parts or to the interior components of the machine.
Z14 Manual Mode: The display will show the number of oranges to be squeezed. The machine is now
ready for operation.
Z14 Self-service Mode: When the machine is ready to work, the display shows the "machine icon and
the orange icon".
(Operator faults not covered by the guarantee)
34
Tabla de contenido
loading

Tabla de contenido