Idiomas disponibles
Idiomas disponibles
7.
Make sure all cables are routed to the left of the chute control
rod. Line up the hole in the rod with the arrow on the input shaft
and insert the end of the rod into the input shaft below joystick on
handle panel. See Figure 7.
NOTE: The chute control rod will fit snuggly into the input shaft.
Support the rear of the dash panel with one hand while inserting the
rod with your other hand to ensure the rod is inserted
the input shaft.
8.
Now push the chute control rod back towards the handle panel
until the hole in the rod lines up with the hole in the chute control
input closest to the chute control head. Insert the cotter pin. See
Figure 8.
NOTE: The second hole is used to achieve further engagement of the
rod into the input shaft if required and can be used later for adjustment
if the chute does not fully rotate. Refer to the Service & Maintenance
section for Chute Control Rod adjustments.
9.
Finish securing chute control head to chute support bracket with
wing nut, and clevis pin and bow-tie cotter pin removed earlier. Do
not overtighten. See Figure 9.
ASSEMBLY
all the way
Figure 7
into
10
Figure 8
Figure 9
