Ubermann UHD04CHI Manual Del Operador página 26

FEATURES
PRODUCT SPECIFICATIONS
No-load speed .................................................0 - 450 / 0 - 1,650 RPM
Torque ................................................................. 62.14 Nm (550 in.lb.)
ASSEMBLY
This product requires assembly.
• Carefully remove the tool and any accessories from the box.
WARNING:
Items in this Assembly section are not assembled to the product
by the manufacturer and require customer installation. Use of a
product that may have been improperly assembled could result
in serious personal injury.
WARNING:
If any parts are damaged or missing do not operate this product
until the parts are replaced. Use of this product with damaged
or missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create accessories or
attachments not recommended for use with this product. Any
such alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal injury.
0-5,850 / 0-21,450 BPM
6 — English
Torque adjustment ..........................................................24 positions
Chuck ............................................................................ 1/2 in. (13 mm)
Installing/removing the auxiliary handle assembly
See Figures 1 - 2, page 12.
The auxiliary handle assembly has handle position options.
To install the auxiliary handle assembly:
• Remove the battery pack.
• Turn the handle grip counterclockwise to loosen it and open
the hooks wide enough to fit over the mounting ribs, behind
the torque adjustment ring.
• Place the hooks over the mounting ribs, making sure the hooks
are positioned in the slots as shown.
NOTE: Make sure the notches on the inside of the auxiliary
handle engage the tabs on the drill housing.
• Turn the handle grip clockwise to tighten. Make sure the
handle assembly is secure before beginning operation.
To remove the handle assembly and install it on the opposite
side:
• Turn the handle grip counterclockwise to loosen and remove
the handle assembly.
• Reinstall the handle assembly in the desired position.
NOTE: The auxiliary handle assembly may also be installed in
a vertical position as shown.