Idiomas disponibles
Idiomas disponibles
Do not drive nails on the top of other nails or with
Nailer at too steep of an angle; nails can ricochet
and hurt someone.
Do not drive nails into thin boards or near corners
and edges of workpiece. Nails can be driven
through or away from workpiece and hit
someone.
Never drive nails from both sides of a wall at the
same time. Nails can be driven into and through
the wall and hit a person on the opposite side.
Never use Nailer which is defective or operating
abnormally.
Do not use Nailer as hammer.
Disconnect battery and fuel cell from Nailer when:
1) it is not in use;
2) leaving work area;
3) moving it to another location; and
4) handing it to another person.
Be careful of unwanted fastener.
If pulling the trigger more when not driving nail at
the temperature below 30°F (0°C), an wanted
fastener will be driven.
This Nailer is equipped with a FULL SEQUENTIAL
ACTUATION MECHANISM.
Explanation of FULL SEQUENTIAL ACTUATION
MECHANISM nailing operation;
First, press the push lever against the workpiece;
next, pull the trigger to drive a nail.
The machine employs a preventive mechanism for
unloaded operation.
The machine enters a state where the push lever cannot be
pushed up. This takes place when the magazine is not
loaded with nails or when the remaining number of nails
becomes less than 8 or 9.
CAUTION
Use caution not to throw the push lever tip onto
wood when the push lever cannot be pushed up.
METHODS OF OPERATION
CAUTION
Squeeze the trigger when drive a nail, otherwise
the piston can not return correctly.
Make sure the nailing depth when the temperature
is above 85°F (30°C) or below 50°F (10°C).
This Nailer is equipped with the push lever and does not
operate unless the push lever is depressed (upward
position).
It is intermittent operation (Trigger fire) only.
1 Position the nail outlet on the workpiece with
finger off the trigger.
2 Depress the push lever firmly until it is completely
depressed.
3 Pull and squeeze the trigger to drive a nail.
4 Remove finger from the trigger.
To continue nailing in a separate location, move the
nailer along the wood, repeating steps 1 - 4 as
required.
2
Push lever
ADJUSTING THE NAILING DEPTH
To assure that each nail penetrates to the same depth, be
sure that the Nailer is always held firmly against the
workpiece.
If nails are driven too deep or shallow into the workpiece,
adjust the nailing in the following order.
1 Remove the fuel cell and the battery from the Nailer.
2 Loosen the bolt with wrench.
3 If nails are driven too deep, move the push lever to
forward.
Push lever
If nails are driven too shallow, move the push lever to
backward.
4 Stop moving the push lever when a suitable position is
reached for a nailing test.
— 17 —
3
Trigger
Fuel cell
Battery
English
