Sony Caller ID IT-M602 Manual De Instrucciones página 14

Making calls (continued)
Additional tasks
To
Adjust the handset volume
Adjust the speaker volume
Adjust the ringer volume
Put a call on hold
Mute your voice
Switch to tone dialing
t e m p o r a r i l y
Notes
• When another extension connected to LINE 1 or LINE 2 is in use, the LINE 1
or LINE 2 button flashes.
• When another call comes in on the other line, the corresponding line button
flashes, but the phone won't ring. (see page 18).
Tips
• You can switch to speakerphone during conversation by pressing
(SPEAKERPHONE). Then you can replace the handset in the cradle.
To switch back to the handset, pick up the handset again.
• If you pick up another phone connected to the same phone line, the hold will
be automatically released and you will be able to resume conversation on
that phone.
• When you pick up the handset or press (SPEAKERPHONE), the vacant line is
automatically connected. When neither line is in use, line 1 is connected.
14 EN
Basics
Do this
During phone conversation, set the HANDSET
VOLUME switch. You can select from three
level positions.
Slide the SPEAKER VOLUME control.
You can adjust the ringer level of line 1 and 2
respectively. Set the RINGER LEVEL LINE 1 or
LINE 2 switch to H (high) or L (low); to turn the
ringer off, set to OFF.
Press (HOLD). The LINE 1 or LINE 2 button
will flash slowly.
Press (LINE 1) or (LINE 2) to resume the
conversation.
Press (MUTING) to disable the microphone. The
MUTING lamp lights up. Press
to cancel.
Press TONE (*) after you're connected.
The line will remain in tone dialing until
disconnected.
(MUTING) again