Domo DO1087K Manual De Instrucciones página 23

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
PARTS
1.
Selection button
2.
Espresso button
3.
Steam button
4.
Portafilter
5.
Drip catcher
6.
Water reservoir
7.
Steam pipe
8.
On-off button
9.
Small filter
10. Large filter
11.
Retainer clip portafilter
12. Measuring spoon
BEFORE FIRST USE
Check whether all accessories are included with the appliance and whether or not the appliance is
damaged.
First run some water through it without adding coffee. Fill the water reservoir to the maximum line. Place
a cup under the drip catcher. Put the plug in the socket and press the on-off button. The indicator lights
will flash. Press one of the buttons to allow the water to run through. Then throw the water away. The
appliance will go into standby mode.
USE
COFFEE
1.
Fill the reservoir with the desired amount of water. Make sure the water level stays between the
"MIN" and "MAX" lines on the reservoir. The reservoir can be removed by using the handle to pull it
toward you.
2.
Put the plug in the socket and press the on-off button.
3.
Turn the selection button to the middle position "0". The appliance will begin to heat up and the
indicator lights will flash. While heating, a small amount of water may be deposited into the drip
catcher via a hose at the bottom of the appliance. This is normal.
4.
Select the desired filter
a. the small filter for an espresso
b. the large filter for 2 cups or a double espresso
5.
Press the filter in the portafilter.
6.
Fill the filter with fresh, finely ground espresso coffee using the measuring spoon.
7.
Press the ground coffee firmly and evenly using the presser on the back side of the measuring spoon.
8.
Remove any excess coffee from the edge.
www.domo-elektro.be
1
2
3
4
5
6
7
8
a
b
9
10
11
12
23
DO1087K
loading