Idiomas disponibles
Idiomas disponibles
EN
IMPORTANT INFORMATION
Any incorrect use or improper handling of the product shall render the warranty null and void.
Prior to plugging in the product, check that your mains voltage is the same as the one indicated
on the product label.
The mains connection cable must not be tangled or wrapped around the product during use.
Do not use the device, or connect and disconnect to the supply mains with the hands and / or feet
wet. Do not pull on the connection cord in order to unplug it or use it as a handle
Only fill the kettle with water. Milk and instant beverages will burn and damage the appliance.
Never operate the kettle without water and do not over fill it; observe the min and max markings.
If the kettle is too full, the water will boil over!
Do not put the jug on a stove or in a microwave for re-heating of water.
Always place the kettle on a stable, smooth, flat surface; the power cord must not hang loosely on
the edge of a table (or any other work surface) or touch a heated surface.
Do not use the kettle with the lid open.
Do not remove the lid when the water is boiling.
If the internal electrical elements are flooded with water, make sure the kettle is completely dry
before plugging in.
Do not move while the kettle is switched on.
Unplug the product immediately from the mains in the event of any breakdown or damage and
contact an official technical support service. In order to prevent any risk of danger, do not open the
device. Only qualified technical personnel from the brand´s Official technical support service may
carry out repairs or procedures on the device.
B&B TRENDS, S.L. will not be held liable for any harm or damage which may occur to people,
animals or objects as a result of failure to observe the aforementioned warnings.
INSTRUCTIONS FOR USE
BEFORE USE
Make sure that all the product's packaging has been removed.
Before connecting of the jug kettle check that voltage indicated on the rating label corresponds
the mains voltage in your home.
Place the scale filter.
Before heating water for the first time, we recommend using the kettle twice, in order to clean the
system.
BOILING WATER
1. Pull out the lid release flap (3) and fill the kettle with fresh water through the open lid (2). Ensure
the scale filter is placed.
2. Read the quantity on the water level indicator (1). Do not fill less than the minimum and not
more than the maximum marks indicated. Too little water will cause the kettle switching off before
the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boi-
15
