STEP 17
Loosen the floating back plate
screws just enough to raise it until
the top glide stop is in the top
glide rail (it should rest within the
rail but not touch the top of it), then
retighten the floating back plate
Fig. 13
and open and close the pantry
to ensure proper function. After
floating back plate is in desired
position, secure it using (2) #8 x 1
deep thread flat head (See Fig. 22).
Note: Do NOT over-loosen the
floating back plate screws - it will
cause the tapered barrel nuts to
fall behind the pantry, and you
is is a safety feature that has
will have to uninstall the pantry
to gain access.
STEP 18
On the front of the pantry loosen
lock nut to position the door
mount brackets to the desired
locations (See Fig 23).
(Note: you will want to ensure
that the brackets mount into the
thick portion of the cabinet door.
Fig. 14
STEP 19
Measure hole locations and
transfer to the cabinet door. Attach
the door with (6) #6 x 1/2 wood
screws (See Fig 24).
STEP 20
To adjust the door tilt loosen or
tighten the adjustment screw
located on the underside of the
slide (See Fig. 25).
Utilisez fourni autocollant à vis du couvercle. (facultatif) Fixez (2) pourvu butoirs en caoutchouc à l'intérieur du cadre face du placard.
Door/Shelf installation
Puerta / estante de instalación
Porte / Installation de la tablette
Loosen T-nuts to allow door brackets to be positioned to desired locations. (Note: you will want to make sure that
17
the brackets will mount into the thick portion of cabinet door.)
T-A oje las tuercas para que soportes de la puerta para ser colocado en lugares deseados. (Nota: usted querrá asegurarse de que los soportes se montará
en la parte gruesa de la puerta del gabinete.)
T-Desserrer les écrous de permettre supports de porte à être placé à des endroits désirés. (Note: vous voulez vous assurer que les supports doivent être
dans la partie épaisse de la porte de l'armoire.)
INSTALLATION INSTRUCTIONS: WOOD PANTRY PULLOUT
FIG. 22
Floating
back plate
screws
FIG. 23
T-Nut
Lock nut
T-A oje
T-Desserrer
Fig. 17
FIG. 24
FIG. 25
Adjustment
Screw
Floating
back plate
Fig. 16
#8 x 1 Deep
thread Flat Head
Screws
7
