Idiomas disponibles
Idiomas disponibles
E N G L I S H
1. The burnt-out element shows
cleat signs of melting of the
external copper tube.
2. The burnt-out element is a
whitsh colour with blisters all
along the heating element
surfaces
1. Steam iron does not heat.
2. Steam iron overheating.
3. From the iron comes water
mixed with steam.
4. Steam overheated from the
iron.
BREAKDOWNS TO THE STEAM/AIR SPOTTING GUN (IF FITTED)
1. Steam
available
machine, but pushing the gun
button no steam available
from nozzle.
1. The exhaust fan does not
work.
b) Pump Motor burned.
BOILER HEATING ELEMENT BURNT OUT
1. Lack of water in the boiler due
to
malfunctioning
electronic level control.
2. The heating element is covered
with thick scaling that inhibits
the diffusion of heat
STEAM IRON
1. Causes:
a) Break of cable continuity.
b) Iron resistance burned.
c) Iron
faulty.
2. Thermostat contacts faulty.
3. Causes:
a) Iron temperature too low.
b) Boiler
anomalies of the boiler itself.
4. Iron temperature too high.
to
the
1. Causes:
a) Microswitch contact defective.
b) Break
continuity.
c) Solenoid valve coil burned.
EXHAUST FAN BREAKDOWNS
1. Causes:
a) Foreign objects block the fan.
b) The micro-switch on the pedal
does not work.
c) The
burned out.
d) The motor is burned out.
C H A P T E R 4
of
thermostat
contacts
suction
due
of
the
gun
cable
motor
condenser
Page 4-8
b) Replace the pump motor.
More
frequent
maintenance is recommended
in
the
future
"MAINTENANCE").
1. See
"BREAKDOWNS
the
THE BOILER AND ON THE
ELECTRONIC
CONTROL".
2. Clean the boiler and remove
all scaling before fitting a new
heating element
More
frequent
maintenance is recommended in
the
future
"MAINTENANCE").
1. Solutions:
a) Repair
the
continuity.
b) Replace
resistance.
c) Replace the thermostat and
the fuse.
2. Replace the thermostat
3. Solutions:
a) Rotate the iron thermostat
handwheel
increasing
temperature.
to
b) See
"BREAKDOWNS
BOILER"
4. Rotate the iron thermostat
handwheel
decreasing
temperature.
1. Solutions:
a) Check
the
contact and if necessary
replace it.
b) Check the continuity and
repair accordingly.
c) Replace burned coil.
1. Solutions:
a) Unblock the fan by removing
the foreign bodies that are
blocking it.
b) Change the micro-switch on
the pedal.
is
c) Change
condenser.
d) Change the motor.
E N G L I S H
preventive
(See
Section
ON
LEVEL
preventive
(See
chapter
electric
cable
the
burned
clockwise,
the
iron
paragraph
TO
THE
anticlockwise,
the
iron
microswitch
the
motor
