Idiomas disponibles
Idiomas disponibles
E N G L I S H
scaling. This is of a great importance for the
performance of the boiler, and it is easy to do.
Simply remove the flange with the heating
elements and carefully clean them. During this
operation it is important to disconnect the tube
that connects the pump to the boiler, and
clean the joint, where the water enters into the
boiler, of any deposits that may be obstructing
it.
b) Check the various gaskets and gate valves as
continuous heating and cooling can cause
leaks. Should there be leaks, remove the
gaskets and gate valves and replace with new
to prevent further leaks.
c) Clean the water filter fitted to the feed
electrovalve. To do this, remove the sleeve,
remove the filter inside the electrovalve and
clean the latter with compressed air.
d) Disconnect the copper pipes that connect the
gauge and the pressure gauge and clean
them internally to remove any scaling.
e) Remove the probe and carefully clean it of
any sediment or scaling using an emery cloth.
Assuring that the spindle/electrode doesn't
revolve in the sonde support body, otherwise
tighten the superior nut.
Problem:
1. The
pump
works
produces a strange noise
without stopping
2. The boiler does not gain
pressure.
BREAKDOWNS ON THE BOILER AND ON THE ELECTRONIC LEVEL
1. The water feeding valve is
open,
but
the
station alarm is on (red led is
blinking
and
beeping).
2. Water is sucked back during
steam generation at ironing
start.
BREAKDOWNS
IMMEDIATELY FOLLOWING INSTALLATION
and
1. Water
machine
2. The drainage gate valve is not
tightly closed.
1. Water is not fed into the boiler
electronic
and the station is signalling the
error.
alarm
is
2. Causes:
a) The machines has not been
used for several hours.
b) The ball valve on the water
pipe was not closed on the
previous evening.
c) The ball valve is out of order
and does not close properly.
C H A P T E R 4
f)
Check the condition of all the labels and
plates
instructions). If they are in poor condition,
replace them.
g) Carry out a visual inspection inside the boiler,
at least once a year, to control the conditions
of the inside walls and the presence of
possible scales and/or corrosions. Carefully
clean the inside of the pipe containing the
probe.
h) Disassemble the safety valve and clean the
joint, on which is assembled, of any scaling.
Also check that the valve is not obstructed.
i)
Clean the air pipe from any impediment (dirty)
that stops the airflow during the ventilation
phase.
j)
Check the wear of the board padding and, if
necessary, substitute it. The board padding is
considered a part of the normal wear and tear
since ironing tends to matt the padding and
decreases
capacities of the board.
Causes:
is
not
reaching
CONTROL
Page 4-6
on
the
machine
the
aspiration
Action:
the
1. Check the reason for the water
not reaching the machine.
Letting the pump run without
water will damage it beyond
repair.
2. Close the drainage gate valve
1. Check that water is actually
fed into the machine and, if
necessary,
passages
as
Pos.5.
2. With the machine in operation,
drain water from the boiler by
opening the boiler drain ball
valve slowly until the pump
starts re-loading water. Now
close the drain cock.
E N G L I S H
(warnings
and
and
steaming
clean
the
indicated
at
