Troubleshooting - Altrad TUBMIX 50 Manual Del Operador

GB

10. Troubleshooting

HAVE YOUR TOOL REPAIRED BY A QUALIFIED PERSON
This electric tool complies with the relevant safety rules. Repairs should only be carried out by
qualified persons using original spare parts, otherwise this may result in considerable danger to the
user.
Fault
The machine does not function.
Machine is difficult to start.
Unusual noise coming from the
reduction gear.
Cause
The power supply cable is
damaged or not
connected.
No voltage in the socket.
The thermal protection has been
activated.
Internal emergency switch has
been damaged.
Mixture too hard.
The agitator is encountering
obstacles whilst rotating (stones
or lumps).
Start capacitor is damaged.
Bearings or bushings of reduction
gear are damaged.
Reduction gear damaged.
6
Remedy
Press the plug firmly into the
properly power socket.
Have the socket checked.
Remove the power supply cable
from the main socket and reset
the thermal protection. In case
this is not possible, wait a few
minutes to allow it to cool.
Consult local dealer.
Remove part of the mixture from
the basket, than try to start the
machine.
Remove the stones which are too
big or the lumps. Proceed as
above indicated.
Consult local dealer.
Consult local dealer.
Switch
immediately and contact your
local dealer.
off the machine