Idiomas disponibles
Idiomas disponibles
and connect the air supply hose to the
tool. Set the air pressure at 90 PSI.
Push forward the throttle lever lock and
press down on the throttle lever. How far
the throttle lever is pressed determines
the tool rotation speed. Then the tool
starts to work.
CARE AND MAINTENANCE
The tool should be lubricated daily (or
before each use) with air tool oil (not
included).
NOTE: Air tool oil is available at major tool
hardware stores.
SAE #10 weight oil or sewing machine
lubricant or any other high grade turbine
oil containing moisture absorbent, rust
inhibitors, metal wetting agents and an EP
(extreme pressure) additive may be used
as a substitute. Do not use detergent oil.
During continuous operation, the tool
should be oiled every 1 to 2 hours. This
may be done using an in-line oiler, or
manually. If done manually, proceed as
follows:
Disconnect the tool from air supply.
Place a few drops of air tool oil into the
air inlet.
NOTE: Avoid the misuse of thicker
oil which may lead to the reduced
performance or malfunction.
Connect the tool to the air supply. Run
the tool without load for a few seconds to
distribute the oil through the tool.
NOTE: Any excess oil may be propelled
from the collet area. So keep the tool
away in a safe direction.
After operating the tool and before
storing the tool, disconnect the air hose
and place 4 or 5 drops of air tool oil into
the air inlet, then re-connect the air hose
and run the tool to evenly distribute the
52
