Probuilder 69361 Manual De Instrucciones página 51

GRINDER PARTS
4
3
2
1
1 Collet hole
2 Collet fixing cap
3 Throttle lever
4 Throttle lever lock
5 Air inlet
USE
Lubricate the tool before operating. See
"CARE AND MAINTENANCE" section for
oiling instructions.
Loosen the collet fixing cap (Part #30) at
counterclockwise direction by hand or
by one wrench while holding the other
wrench on the flats of the collet base
(Part #25).
Insert a grinding accessory like a grinding
stone into the collet hole.
5
Tighten the collet fixing cap at clockwise
direction by one wrench while holding
the other wrench on the flats of the collet
base. Make sure the collet fixing cap is
securely tightened.
WARNING: Only use grinding accessories
that have an RPM rating equal to or
greater than the tool itself.
Remove the air cap from the tool air inlet
51
GB