Idiomas disponibles
Idiomas disponibles
MAINTENANCE
CAUTION:
First unplug the vacuum cleaner.
How to Remove the Bottom Plate
1. Place the vacuum cleaner in the lowest
position by stepping on the handle release
pedal (see "How to Adjust the Handle" on
page 8). Turn the vacuum over on a flat
surface, exposing the bottom plate.
2. Remove the five screws holding the
L-shaped bottom plate in place
3. Remove the bottom plate.
How to Replace the Belt
1. Turn over the unit and remove the bottom
plate as described above.
2. Lift out the brush roll and remove the old
belt
(Fig. 2).
3. Loop the new belt around the drive shaft
and the raised ring between the
(Fig. 3)
bristles on the brush roll
4. Pull the brush roll forward (against the pull
of the belt) and reinsert the ends back into
the nozzle
(Fig. 5)
end opposite the belt so the flat edges slide
down properly.
5. Turn the brush roll by hand, making sure
the belt is not twisted and all rotating parts
move smoothly.
6. Replace the bottom plate and the
five screws.
(Fig. 1).
(Fig. 4).
making sure to line up the
Screw
points
Drive
shaft
12
