Idiomas disponibles
Idiomas disponibles
The suction
power of the
water is weak
The poles of the
battery
terminals heat
up or melt.
The water is not
completely
sucked in.
The machine
does not clean
thoroughly.
1. The sealing ring on the
wastewater tank lid is loosening.
2. The hose hoop is loose.
3. The suction engine becomes
loose.
4. The suction hose is clogged.
5. The hose is damaged.
1. The cable ends are not
tightened enough.
2. There are black metal washers
between the cable ends and the
crimp terminals.
1. The water suction engine is not
working.
2. The water suction hose is
clogged.
3. There are foreign bodies in the
wiper.
4. The wiper is excessively worn.
5. Inadequate wiper height.
1. Brush engine does not run.
2. The dirt is too persistent.
3. The brush is excessively worn
4. The brush is blocked by a
foreign object.
1. Correctly attach the sealing
strip without gaps.
2. Check the hose hoop and
install it correctly.
3. Open the muffler cover, and
make sure the engine is properly
installed.
4. Clean the air inlet and outlet.
5. Repair the damaged hose.
1. Tighten the screw.
2. Remove the washers and
connect the ends of the cable
directly to the poles of the
battery.
1. Check the engine.
2. Remove the foreign object.
3. Remove the foreign object.
4. Change the used wiper edge or
replace the wiper.
5. Adjust the height of the wiper.
1. Check the engine.
2. Use a special-purpose
detergent and sprinkle it on the
floor.
3. Replace the brush.
4. Remove the foreign object.
