Using The Gun Trigger Lock - Titan RX-Pro Instrucciones De Uso

INtRoDuctIoN
This airless spray gun is to be used for the high pressure atomization of liquid
coating materials.

uSING tHE GuN tRIGGER lock

Always engage the gun's trigger lock
when the gun is not in use.
1. To lock the trigger, push in the trigger
lock from left to right, when looking
at the rear of the gun.
2. To unlock the trigger, push the trigger
lock from right to left, when looking
at the rear of the gun.
NEVER point the spray gun at yourself.
SEtuP
Never attempt to assemble, change, or clean the gun, tip, or tip
guard without first relieving pressure from the spray system. Follow
the "Pressure Relief Procedure" in the sprayer's Owner's Manual.
Always use a tip safety guard for added protection against injection.
Beware that the guard alone will not prevent injection. Never cut
off tip guard! Always engage gun trigger lock when the gun is not
in use. Before servicing equipment, consult Owner's Manuals and
follow all warnings.
1. Set up the sprayer. Refer to the instructions in the
sprayer's Owner's Manual.
2. Attach a grounded, airless spray hose to the
material inlet on the gun. Using two wrenches
(one on the gun and one on the hose), tighten
securely.
3. With the tip and tip guard off the gun, start the
sprayer. Flush and prepare the spray system
according to the sprayer's Owner's Manual.
Inspect the spray system to make sure that all
fittings are secure and that there are no leaks.
4. Perform the "Pressure Relief Procedure" described in the sprayer's Owner's
Manual.
5. Using a the end of the spray tip (5), insert the tip seal (3) and seal (4) into the
back of the tip guard (2). Press in for final adjustment.
RX-Pro
1
Gun locked
(gun will not spray)
5
1
2
Gun unlocked
(gun will spray)
2
4
3
5
GB