Titan RX-Pro Instrucciones De Uso página 9

6. Make sure the two retractor pins (4) inside the gun head are still in the
correct position.
7. Insert the packing seal assembly into the rear of the gun head and thread it
by hand until it stops.
8. Using a 3/8" socket, tighten the packing seal assembly (3). Torque to 5 Nm
(3.7 ft./lbs.).
9. Grease both ends of the packing spring (2) and place it over the packing seal
assembly in the gun head.
10.Place the end cap (1) over the packing spring (2) so that the pilot inside the
end cap seats inside the packing spring.
11.Push the end cap (1) toward the gun head while threading it into the gun
head. Using a wrench, tighten the end (1) cap securely.
REvERSING tHE DIFFuSER SEAt
1. Using a wrench, loosen and remove the diffuser from the front of the gun head.
2. Remove the diffuser O-ring from the front of the gun head.
3. Remove the seat from the gun head. Flip it around and reinstall back into
the gun head.
4. Reassemble the diffuser by reversing steps 1-2.
REPlAcING/REmovING tHE FIltER
The gun filter should be cleaned after every use.
i
1. Unclip the top of the trigger guard from the gun head.
2. Using the bottom of the trigger guard as a wrench, loosen and remove the
handle assembly from the gun head.
3. Pull the old filter out of the gun head. Clean or replace.
4. Slide the new filter, tapered end first, into the gun head.
5. Thread the handle assembly into the gun head. Tighten with the trigger wrench.
6. Snap the trigger guard back onto the gun head.
FIltER cHARt
Part Application
Number
0089960 Synthetic resin, enamels, clean varnishes, stains,
azures
0089959 Base coat enamels, primer enamels, fillers,
marking paints, textured enamels
0089958 Emulsions, latex paints, acrylic paints
0089957 Filler paints, large area surfaces
RX-Pro
Filter Filter
type color
Extra-fine Red
Fine Yellow
Medium White
Coarse Green
GB
9