Fig. 5
5. With the unit lying face down, measure from top left to bottom right and from top right to bottom
left. If the unit is square, the measurements will be equal. If one measurement is longer, tap the
bottom of the longer side panel until equal. Place Back (G) on the unit and attach using
#6x5/8" Philtruss Screws (O) through the pre-drilled holes and into each side assembly and upper
and lower sleepers. See Figure 5.
Fig. 6
6. Apply a thin layer of glue in the dowel holes in the Drawer Front (H). Insert Drawer Sides (Ia and Ja)
and gently tap with a mallet. Using a damp towel, quickly wipe up any excess glue. Insert #8x1-1/4"
Pan Head Screws (Nb) through drawer sides and into drawer front. See Figure 6.
7. Slide Drawer Bottom (L) into grooves in drawer assembly.
O
O
G
L
Fig. 7
O
Page 5 — 629Wc — 10/14
