Idiomas disponibles
Idiomas disponibles
Assembly - Hanging the Fan (continued)
7
Mounting the fan motor assembly
(standard mount)
□
Align the locking slots of the canopy (C) with the two
screws (II) in the slide-on mounting bracket (A). Push up to
engage the slots and turn clockwise to lock in place.
□
Firmly tighten the two mounting screws (II).
□
Install the two canopy screws (HH) (saved from Assembly-
Step 1 "Preparing for mounting") into the holes in the
canopy (C) and tighten firmly.
□
Install the decorative canopy ring (FF) by aligning the ring's
slots with the screws in the canopy (C). Rotate the ring
clockwise to lock in place.
Assembly - Attaching the Fan Blades
1
Attaching the blades to the motor
NOTE: Blade installation must be properly completed before
attaching the light kit.
□
Attach a blade (F) to the fan motor assembly (E) by
inserting the blade (F) into the slot in the side of the fan
motor housing (E) until it stops. The locking clip (LL) will
click when the blade is correctly installed. Ensure the blade
is snapped into locking clip (LL) completely by pulling the
fan blade away from the motor housing.
□
Repeat these steps for the remaining blades (F).
Removing the blades from the motor
NOTE: Make sure you have turned the black plate with notch
towards the blade you would like to remove.
□
Pull the blade locking pin down and turn to the right. Make sure
the pin is engaged with the black slot properly.
□
To remove the blade (F) from the fan motor assembly (E),
squeeze the tab of the locking clip (LL) towards the direction of
blades and pull the fan blade away from the motor housing.
□
Repeat these steps for the remaining blades (F).
II
Pin
11
Please contact 1-855-HD-HAMPTON for further assistance.
A
B
HH
FF
C
D
E
E
LL
F
Pin
Clip
HAMPTONBAY.COM
