Holmatro GCU 50 i EVO 3 Manual página 41

• Switch on the tool using the on/off switch.
NOTICE
It is highly recommended to have at least one fully charged spare battery pack available at
all times.
NOTICE
To protect the battery pack, the tool will stop as soon as the battery pack gets empty. It might
happen that at that time the tool is fixated. To remove the tool it is best to replace the battery
pack by a fully charged one. When this is not possible the battery pack can be activated
again by pushing the SOC indicator button. To prevent damaging the battery pack, this can
only be done a limited number of times.
6.4 Tool movement
The cutting blades close relatively quickly until they encounter resistance. Then the pump will build up
the required pressure for the cutting action.
WARNING
Take extreme care during tool movement. Because of the enormous power of the tool parts
of the body can easily be crushed or pinched.
6.5 Cutting
See Fig. 8 and Fig. 9.
CAUTION
Do not cut hardened fastenings, bolts, etc. because this can damage the blades.
• Open the blades.
• Place the tool with opened blades perpendicular to the object to be cut.
• Place the object to be cut as deeply as possible in the cutting opening.
• Close the blades.
WARNING
Stop immediately if the blades are out of line. Danger of serious injury and of serious damage
to the equipment.
6.6 After use
6.6.1 Inspection
• Check the battery level. Recharge the battery pack, if necessary. See section 3.6.
• Check the unit for completeness, leaks and damage. Do not use the unit if it leaks or is damaged
and contact the Holmatro dealer.
• Check the accessories used for completeness and damage. Replace them if the damage is
considerable.
• Inspect the tips. Replace them if the damage is considerable.
• Check the operation of the deadman's handle. It must return to the neutral position when you
release it.
• Check that the carrying handle is firmly attached.
GCU 50* (i) EVO 3
All manuals and user guides at all-guides.com
916.001.652_002
EN
41