Orbegozo SP 6000 Manual De Instrucciones página 17

SP 6000
Note: If not setting the temperature and weekly program, the product will automatically turn-off after 12
hours of continuous work and enter into standby.
Function operation (ONLY by remote control)
Note: During use of remote control ensure it aim to receiver on appliance to work correctly.
1. Set current TIME/DAY (can set both under standby mode & working status): Press
time, the display shows the hour, press "
shows minutes, press "
display shows the day "
confirm the setting, display will show previous settings. For example: setting to Wednesday, 9:30 under
25ºC under heating II, please refer to the following photos:
Note: about setting HOUR/DAY, it keeps while the appliance is working or in standby. If you switch off or
unplug this configuration will erase and you have to set it again.
2. Set temperature. During working status, press "
desired temperature (temperature range 10-49ºC), press
room temperature is 15ºC, when set temperature to 25ºC, the display shows as below:
Note: When setting temperature, appliance will use SMART working way:
- If room temperature is 2ºC or lower than set temperature, the heater will work in max power heating.
- If room temperature is less than 2ºC of set temperature without reach it, heater will work in min power
heating.
- If room temperature is the same as set temperature, heater will work in fan mode for 30 seconds to cool
down the appliance and protect its components, after that it will enter in standby mode.
- After this situation if room temperature is lower than 2ºC of set temperature, heater will turn on again
and work as same way.
/ " to set current hour (24 hours); press
/ " to set current minute (00-59 minutes), then press
", press " / " to set current day (Monday-Sunday: d1-d7). The press
/ ", display shows "23" as default. Press "
to confirm the setting. For example: the
button for one
again, display
for third time, the
to
/ " to set
17