Samsung WF455ARGSWR Manual Del Usuario página 22

Idiomas disponibles

Idiomas disponibles

installing your washer
5. Slide your washer into position.
6. Level your washer by turning the leveling legs in or out as
necessary by hand or by using the wrench included with
your washer.
When your washer is level, tighten the locking nuts using
the wrench or (-) flathead screwdriver.
7. Plug the power cord into a 3-Prong, well grounded
120 volt 60 Hz approved electrical outlet protected by a
15-amp fuse or comparable circuit breaker.
Your washer is grounded through the third prong of the
power cord when plugged into a three-prong grounded
receptacle.
Your Washer must be leveled on all four sides. A
carpenter's level should be used on all four corners
of your Washer. It's a good idea after the first dozen
washes to recheck your washer's levelness.
Avoid damage to the legs. Do not move
the Washer unless the Locking-nuts are
fastened to the bottom of the Washer.
STEP 4
Calibration mode
Before using Calibration mode, be sure to take out all items from the drum.
Your Samsung washer automatically detects the weight of the laundry.
For more accurate weight detection, please run Calibration Mode after the installation.
Calibration mode is performed by following the steps below.
1. Turn on the washer.
2. Press the Temp button and Delay Start button simultaneously at least 3 seconds.
3. Remove any contents in the tub and close the door.
4. Press the Start/Pause button to run Calibration Mode.
5. The drum rotates clockwise and counterclockwise approximately for for approximately 3
minutes.
6. When Calibration Mode is finished, the "En/End" appears on the display and the washing
machine turns off automatically. The washing machine is now ready for use.
22_ installing your washer
WF455AG-03159A-04_EN.indd Sec3:22
WF455AG-03159A-04_EN.indd Sec3:22
Locking
Nut
Levelling
Leg
2012-11-28
2012-11-28
2:07:28
2:07:28
loading

Este manual también es adecuado para:

Wf455arg serie