Idiomas disponibles
Idiomas disponibles
installing your washer
IMPORTANT NOTE TO INSTALLER
Please read the following instructions carefully before installing your Washer.
These instructions should be retained for future reference.
We recommend you hire a professional for installation of this washer.
Installation flow chart
Selecting a
location
Please
check again
before
steps.
Yes
STEP 1
Selecting a Location
Before you install your washer, make sure the location:
•
Has a hard, level surface without carpeting or flooring that may obstruct ventilation.
•
Has no dust, oil and detergent etc.
•
Is away from direct sunlight
•
Has adequate ventilation
•
Will not freeze (below 32°F or 0°C)
•
Is away from heat sources such as oil or gas
•
Has enough slack for the power cord.
•
Doesn't have any carpeting that will obstruct ventilation openings.
STEP 2
Removing the Shipping Bolts
Before using your Washer, you must remove the four shipping
bolts from the back of the unit.
1. Loosen all the bolts with the supplied wrench.
2. Slide the bolt and spacer up and remove the bolt with the
spacer through the hole in the rear wall of your washer.
Repeat for each bolt.
3. Fill the holes with the supplied Bolt Hole Covers (See page 16).
4. Keep the shipping bolts and spacers for future use.
20_ installing your washer
WF455AG-03159A-04_EN.indd Sec3:20
WF455AG-03159A-04_EN.indd Sec3:20
Removing the shipping
bolts (*Drum only)
Powering your washing
Adjusting the
machine
levelling feet
Does
Running a Calibration mode
your washer
have excess vibration
No
or noise?
Connecting the water
and the drain
[Running a test cycle]
Run a test cycle (Rinse+Spin) with
small amount of laundary (about 4~5
(Refer to the following
description)
Towels)
Finish the
installation
2012-11-28
2012-11-28
2:07:28
2:07:28
