Unpacking And Inspection - Amprobe AM-520 Manual De Uso

Measurement Category II (CAT II) iis for measurements performed on circuit
directly connected to low voltage installation. Examples are measurements on
household appliances, portable tools and similar equipments.
X�
Warning: Read Before Using
• To avoid possible electrical shock or personal injury, follow these
instructions and use the Meter only as specified in this manual.
• Do not use the Meter or test leads if they appear damaged, or if
the Meter is not operating properly. If in doubt, have the Meter
serviced.
• Always use the proper function and range for measurements.
• Before rotating the function range selection switch, disconnect
test probe from circuit under test.
• Verify the Meter's operation by measuring on a known voltage
source.
• Do not apply more than the rated voltage, as marked on the
Meter, between the test probe or between any test probe and
earth ground.
• Use the Meter with caution for voltages above 30 Vac rms, 42 Vac
peak, or 60 Vdc. These voltages pose electrical shock hazards.
• Disconnect circuit power and discharge all high-voltage capacitors
before testing resistance.
• Do not use the Meter around explosive gas or vapor.
• When using the test leads, keep your fingers behind the finger
guards.
• Remove test leads from the Meter before opening the Meter case
or battery door.

UNPACKING AND INSPECTION

Your shipping carton should include:
1 AM-520 or AM-530 or AM-520-EUR or AM-530-EUR
1 Pair of test leads
1 Temperature probe
1 Velcro strap
1
9V (6F22) battery (installed)
1 Users manual
1 Carrying case
3