Peavey PV 15 PM Manual Del Operador página 21

®
Enclosure: Peavey PV 15 PM
Frequency Range (-10 dB, half space): 52 Hz to 21 kHz
Frequency Response (+/- 3dB, half space): 69 Hz to 17 kHz
Sensitivity (1w/1m): 98 dB
Maximum SPL: 119 dB
Transducer Compliment: Sheffield
woofer, 14T 1.4" titanium diaphragm dynamic compression
™
driver on 75° X 75° coverage Quadratic Throat Waveguide
horn.
Nominal Coverage Pattern: 75° by 75°
Electro-acoustic Crossover Frequency: 3 kHz
Input Connections: Combo female XLR and 1/4" TRS phone
jack. It is switchable between mic-level and line-level
sensitivity.
Enclosure Materials & Finish: Wedge-shaped black carpet
covered enclosure with dado joined 1/4" MDF (Medium
Density Fiberboard), and a black powder coated steel grille.
Mounting or Suspension: Steel 1 3/8" pole-mount cup for
stand mounting, four rubber feet for floor use.
Dimensions: (H x W x D)
Front: 16.13 in. x 25.38 in. x 18.00 in.
410 mm x 645 mm x 457 mm
Weight: 47 Lbs. (21.4 kg)
Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian • MS • 39305
(601) 483-5365 • FAX (601) 486-1278 • 80305569 • www.peavey.com
Peavey PV
SPECIFICATIONS
®
Pro 1500+ 15" premium
™
™
Features and specifications subject to change without notice.
EX000074
15 PM
®
ELECTRONICS AND AMPLIFIER SPECIFICATIONS:
Power Amp Ratings:
Woofer - 150 Watts @ less than 0.1% distortion
Tweeter - 50 Watts @ less than 0.1% distortion.
Electronic Input Impedance (Nominal): Primary balanced
input: 20 k Ohms line level sensitivity selected, 2.4 k Ohms
mic level sensitivity selected, 10 k Ohms unbalanced 1/4".
Mic Switch Sensitivity Increase: 30 dB
Infrasonic Filter Protection: 36 dB/octave roll-off
Nominal Amplifier Frequency Response: +0, -1 dB from 10 Hz
to 30 kHz
Woofer Servo Distortion Reduction: 10 dB
Equal Loudness Compensation Dynamic Range: 35 dB,
frequency response of this stage is fully flat 10 dB below full
amplifier power.
Hum and Noise: Greater than 90 dB below rated power
DDT Dynamic Range: Greater than 14 dB
THD and IM: Typically less than 0.1 %
Damping Factor: Greater than 100 @ 1000 Hz, 8 Ohms
Power Requirements of Peavey PV
(domestic): Nominal 110 Watts, 120 VAC, 60 Hz
21
15 PM System
®