Philips Hydraprotect Salon 2000 HP4879 Manual Del Usuario página 7

Important
Check if the voltage indicated on the appliance corresponds to
the local mains voltage before you connect the appliance.
Keep this appliance away from water! Do not use this product
near or over water contained in baths, washbasins, sinks etc.
When used in a bathroom, unplug the appliance after use since
the proximity of water presents a risk, even when the hairdryer is
switched off.
For additional protection, we advise you to install a residual
current device (RCD) with a rated residual operating current
not exceeding 30mA in the electrical circuit supplying the
bathroom.Ask your installer for advice.
Keep the appliance out of the reach of children.
Never block the air grilles.
If the appliance overheats, it will switch off automatically. Unplug
the appliance and let it cool down for a few minutes. Before you
switch the appliance on again, check the grilles to make sure they
are not blocked by fluff, hair, etc.
Always switch the appliance off before putting it down, even if it
is only for a moment.
Using the appliance
Drying
1 Put the plug in the wall socket.
2 Switch the appliance on by setting the airflow slide to position I, II
or III.
3 Select the desired airflow speed by setting the airflow slide to
position I, II or III. (fig. 1)
O = Off
I = Low airflow especially intended for styling
II = Medium airflow for drying and styling
III = Ultra strong airflow for fast drying
ENGLISH
7