Wait a while after starting the grinder until the disc reaches its top speed, only then you can proceed
with your work. Do not use the switch during operation of the grinder to switch it on or off. Switch
button may only be used when the power tool is away from the processed material.
Unplug the power cord from mains socket before commencing any activities related to installation,
adjustment, repair or maintenance.
●
Do not use water or other liquids to clean the grinder.
●
Use brush to clean the grinder.
●
Clean ventilation holes of the grinder regularly to prevent motor overheating.
●
Make periodic breaks in operation.
REPLACEMENT OF CARBON BRUSHES
Replace immediately worn out (shorter than 5 mm), burnt or cracked motor carbon brushes.
Always replace both brushes at a time.
Entrust replacement of carbon brushes to a qualified person. Use only original parts.
All faults should be repaired by service workshop authorized by the manufacturer.
RATED PARAMETERS
Supply voltage
Current frequency
Rated power
No load speed
Spindle thread diameter
Maximum disc diameter
Diameter of disc hole
Protection class
Weight
Year of production
NOISE LEVEL AND VIBRATION PARAMETERS
Sound pressure: Lp
= 87.17 dB(A) K = 3 dB(A)
A
Sound power: Lw
= 98.17 dB(A) K = 3 dB(A)
A
Weighted value of vibration acceleration: a
Do not dispose of electrically powered products with household wastes, they should be utilized in
proper plants. Obtain information on wastes utilization from your seller or local authorities. Used up
electric and electronic equipment contains substances active in natural environment. Unrecycled
equipment constitutes a potential risk for environment and human health.
* Right to introduce changes is reserved.
"Grupa Topex Spółka z ograniczoną odpowiedzialnością" Spółka komandytowa with seat in Warsaw at ul. Pograniczna 2/4 (hereinafter Grupa
Topex) informs, that all copyrights to this instruction (hereinafter Instruction), including, but not limited to, text, photographies, schemes,
drawings and layout of the instruction, belong to Grupa Topex exclusively and are protected by laws accordingly to Copyright and Related
Rights Act of 4 February 2004 (ustawa o prawie autorskim i prawach pokrewnych, Dz. U. 2006 No 90 item 631 with later ammendments).
Copying, processing, publishing, modifications for commercial purposes of the entire Instruction or its parts without written permission of
Grupa Topex are strictly forbidden and may cause civil and legal liability.
OPERATION AND MAINTENANCE
TECHNICAL PARAMETERS
Angle Grinder
Parameter
= 7.736 m/s
h
ENVIRONMENT PROTECTION
2
K=1,5 m/s
2
12
Value
230 V AC
50 Hz
710 W
11000 min
-1
M 14
115 mm
22.2 mm
II
2 kg
2013
