Orbegozo GR 4550 Manual De Instrucciones página 10

Idiomas disponibles

Idiomas disponibles

GR 4550
• Cooking plates must be in the closed position for pre-heating.
• Note: For the first use ONLY, season the plates by applying a thin coat of cooking oil, butter or
margarine to the cooking surfaces and rub in with a paper towel. Exercise care, as the cooking plates will
be hot.
HOW TO USE THE GRILL
• Select your desired temperature level with thermostat knob.
• Close the grill and plug to the mains, the red light (ON/OFF) will switch on, showing the grill is warming.
• It will take 5 minutes to reach the desired temperature, when it happens the green light (ready) will
switch on.
• Open the grill, place on bottom grill place the sandwich, meat or other kind of food.
• Close the grill, the green light will switch off.
• Cook for 3-5 minutes, until the green light turns on again, until the bread is golden or until your personal
taste.
• When the food is ready open the grill by the handle, to avoid touch hot surface. Remove the food with
plastic or wood spatula. Never use metal utensils or knives; they could damage the non-stick coating
from grill plates.
• When you finish of cooking, unplug the grill and let it open to cool down.
OPEN GRILL USING
• Place the grill in a clean and flat surface. The grill can open 180º, to do it pull of the tab placed on the
handle side when the grill is opened about 90º, so you can open it until 180º and you will have a bigger
cooking surface.
• Use the grill in this position to cook burgers, steaks, chicken steaks (no recommended bone-in chicken,
because they will not cook well), fish and vegetables.
• On this way, you can cook two kind of food avoiding mixing their flavors, cooking each one in each
plate. You can also cook different cuts of meat with different thickness, allowing cook each them for
different time.
• For the food will be healthier, the grill allow that the grease fall down for the inclination to the collecting
grease tray, placed under the corresponding opening (back side)
• So that the grease collects perform better their function is recommended to place the feet in the base as
shown in the following image, to create a better slope.
10
loading